Sales Representative Name: Justin Luth
Phone Number: 855-456-2588 EXT. 1004
Category: Saw-Jets
Year: 2015
Make: Northwood
Model: SJ270-S
Under Power: Yes
Voltage: 230v 3phase 60hz
Location: Northeast
Asking Price: $85,000.00
FINANCING AVAILABLE FROM 12 TO 60 MONTHS - ONE PAGE APPLICATION & 3 MONTHS BUSINESS BANK STATEMENTS REQUIRED. CLICK ON FINANCING TAB ON HOME PAGE FOR FURTHER INFORMATION OR CALL US AT 855-456-2588 2015 Northwood NW270-HPS Single Table
Cutting hours 2,742
SERVO MITRE SAW
The Northwood SawJet comes with a 20 HP Saccardo motor and 16 blade for cutting marble, granite, and limestone. The saw is equipped with Smart Saw Feed Function that uses dynamic force feedback to continuously vary cutting speeds, this allows for improved efficiency when cutting quartz and Dektom(tm) stone products. Mitering capabilities through the Wittenstein gearbox and Fanuc drive allow up to 48 degrees of motion.
KMT Pump and Garnett System
In addition to the saw-motor, the Saw Jet is equipped with an abrasive waterjet head from KMT Waterjet, and is powered by a 60,000 PSI Intensifier Pump. The garnet is fed from a pressurized reservoir to a motor-driven, metered feeder system proximate to the waterjet nozzle. The SawJet software automatically switches between the saw and waterjet as the condition demands, and blends the two cuts as a product of an easy-to-follow calibration routine. In addition, Northwood’s industry-leading StoneVision(tm) 3.0 software, coupled with Alphacam(tm) software by Vero Software, takes the difficulty and risk out of processing drawings or digitized data into machine toolpaths.
The Northwood SawJet integrates a complete run of high-pressure stainless steel piping. The piping lines are contained in a dual chamber energy chain, providing proper protection and control of each line. This system improves the life and reliable of the hp pressure lines.
Fanuc Servo Driven Ground Ball Screws
The Northwood SawJet is controlled by a FANUC Servo control system closely integrated with a 40mm ground ballscrew This combination is designed to provide years of trouble free operation and also provide the highest level of accuracy. Northwood’s interface software and machine control allow an operator to quickly load and run part programs, as well as perform other machine tasks. In addition, Northwood’s industry-leading StoneVision(tm) 3.0 software, coupled with Alphacam(tm) software by Vero Software, takes the difficulty and risk out of processing drawings or digitized data into machine toolpaths.
Mounted Camera system and calibration means for taking accurate slab photos
Bar Code Reader for quickly loading work programs and other information
Cleanout-system ready tanks and drain connections
Industrial air hookup with particulate filter and coalescing filter with auto-drains
Solenoid-actuated dual-side flood coolant for the saw blade
Single, industrial, fused, lockable, disconnect for all incoming power
Conduit wire-hose management system for all floor cabling
Remote machine control diagnostics
StoneVision fabrication software & AlphaCAM
Corrosion resistant paint, hardware, and rails
Lifetime phone support and personnel training
Source:
https://northwoodmachine.com/stone/sawjet/
*video of machine in operation*
IMG_89421065
Machine is available for inspection if necessary.
Machine will be sold as is / where is and implies no warranties.
Buyer responsible for tear down, rigging, freight and installation.
Subject to prior sale.
